Tel: +27 (0)11 451 – 8500 | Email: sales@bearingcorporation.co.za

Self-aligning ball bearing

By Team BC on 31 August 2017 in Products & Services
24


 

Self-aligning ball bearing

this type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.

However, depending on the surrounding structure, such an angle may not be possible.

 

About the Author

Team BCView all posts by Team BC